Skip to content
Serving Nassau & Suffolk Counties since 1993

Roof Flashing Repair on Long Island

Flashing at walls, valleys, dormers and vent pipes, repaired or replaced so the joints in your roof stop letting water in. Free estimates from Scott, the owner.

Roof flashing repair on Long Island

The metal that keeps the joints dry

Shingles are good at shedding water on an open slope. Where the roof meets something else, a wall, a dormer, a second roofline or a pipe, shingles can’t do it alone. That’s the job of flashing: strips and pieces of metal tucked under and over the shingles so water is steered past the joint instead of into it.

When flashing fails, it’s usually not dramatic. A nail backs out, a piece lifts, the sealant along the top edge dries and cracks, or the metal rusts thin. Water then finds the gap every time it rains. Flashing is behind a large share of the leaks we see.

Scott Sasso, who has owned Advanced Roofing Siding and Gutters since 1993, knows how flashing should be layered and what it looks like when someone has cut corners. We repair it, or replace it where it’s past saving.

New gray architectural shingles along a roof valley, trees beyond

30+Years sealing roof joints

Signs of failing flashing

Where flashing problems show up

Flashing leaks tend to show up near the joint, inside or out. These are the giveaways.

  • A stain where a roof meets a wall. Ceilings below a dormer or a second-story wall often stain when the step flashing has failed.
  • Rust streaks on the shingles. Old steel flashing that’s rusting leaves orange trails and will soon have holes.
  • Cracked or missing sealant. Caulk along the top of flashing dries out. When it cracks, water runs behind the metal.
  • Metal lifted or bent. Wind and ice can pry flashing away from the roof or wall.
  • Leaks in a valley. Where two slopes meet, a lot of water gathers. Worn valley flashing lets it through.
  • A drip near a vent pipe. The rubber collar on a pipe boot cracks in the sun and lets water slide down the pipe.
Charcoal architectural shingle roof with a white-trimmed gable dormer

What we repair

Every joint on the roof

Good flashing works in layers, each piece overlapping the one below like shingles do, so water always runs out and down. Repairs only last if that order is respected. We lift the shingles around the joint, replace the damaged pieces in the right sequence, and seal the edges where sealant belongs, not as a substitute for proper overlaps.

  • Step flashing where a roof slope meets a sidewall or dormer
  • Headwall and counter flashing where a roof meets a wall above it
  • Valley flashing where two slopes meet
  • Vent pipe boots and collars
  • Drip edge along the eaves and rakes
  • Chimney flashing, which has its own page
  • Skylight flashing and seals

If an old flashing leak has soaked the wood, we’ll show you and repair the decking before closing the joint back up.

Fixing the joints

Our Process

1

Contact us and schedule an inspection.

Reach us by phone or form, and say where you’ve seen water. We reply within 24 hours.

2

We evaluate and repair or replace your roof.

Scott inspects the flashing at every joint, explains what has failed, and the crew repairs or replaces it in the right order.

3

Rest easy knowing your house and family are protected.

Old metal and scraps are cleared away, and the joint is left sealed and tidy.

Why Advanced Roofing Siding and Gutters

Flashing done the way it’s meant to be

A tube of caulk is not a flashing repair. We take the time to do it properly.

Layered correctly

Each piece goes back in the right order so water always runs out and down.

Shown, not just told

Scott shows you the failed flashing and explains why it leaked.

Repairs where possible

If a section can be refastened and resealed, we won’t replace the whole lot.

Neat work

We lift and reset shingles carefully and clean up every scrap of old metal.

Owner-run since 1993

More than 30 years of Long Island roofs, family owned and operated.

Fully Licensed & Insured

Plus BBB Accredited with an A+ rating.

Free flashing repair estimate

Leak near a wall, valley or pipe?

Tell us where the water appears and, if you can, send a photo of the joint from the ground. We’ll get back to you within 24 hours to book Scott’s visit.

  • Free estimate
  • Reply inside 24 hours
  • Mon–Sat 8–7, closed Sunday
  • Add photos to your request

Get your free flashing repair estimate

Free estimate · Owner-run · Since 1993

Step 1 of 2
Is this an insurance claim?

By submitting, you agree to be contacted by Advanced Roofing Siding and Gutters about your request.

Real Google reviews

Our customers in their own words

Steven Napolitano Google
Advanced roofing was amazing! Scott and his crew did an amazing job all in one day! I would highly recommend! Scott was thorough and was a true professional.
donna carter Google
We are so happy with our new roof, soffits and gutters installed by Advanced Roofing! It was a pleasure working with Scott and his team, everything was explained throughly and done to perfection. I highly recommend Advanced Roofing.
Francine Del Valle Google
Advanced roofing came as a pleasant surprise for me. I was driving through the neighborhood and I seen a bright red truck that advertised the company. We needed a roofer at the time and it was my sign to stop and ask the person driving. Scott is who I met and he was very friendly and approachable. When Scott came to quote us to repair the roof, I immediately thought it was a fair price. But who am I to know? So we called another company in to quote us and what a difference. Not in a good way. The price was about double then advanced roofing. It was no brainer for us to go with the fair price. And that decision was the best decision we made. The level of professionalism from start to finish was excellent. The clean up was very thorough. And the job took about 7 hours. They showed up at 7am and was done by 2:15pm. I was in shock. They play no games about waisting time. The results were stunning and we couldn’t be happier with the new roof. They left my lawn so clean, as if they were never even there. I highly recommend Advanced roofing as the company for your home.
5.0 from 77 Google reviews

Flashing questions

About roof flashing

Ask Scott directly on 516-987-7478.

What is roof flashing?

Thin metal pieces fitted wherever the roof meets a wall, chimney, valley, skylight or pipe. It directs water away from the joint so it can’t run inside.

Can’t you just put sealant on it?

Sealant has a role at certain edges, but it dries and cracks in the sun. A leak that’s only caulked usually returns. Flashing that’s fitted and overlapped correctly keeps water out without depending on caulk.

Do I need new flashing when I get a new roof?

We recommend it. Reusing old flashing under new shingles is a common cause of leaks on new roofs. On a roof replacement we replace it.

My vent pipe leaks. Is that flashing?

Usually. Most pipes have a boot with a rubber collar that cracks over time. Replacing the boot is a common, straightforward repair.

How do I know the leak is from flashing and not the shingles?

Location is the biggest clue. Leaks right below a wall joint, valley, pipe or chimney point to flashing. Scott will confirm it on the roof before anything is done.

HAVE QUESTIONS? CALL US!
516-987-7478
Send a Message
Trusted Products · Trusted Brands · Trusted Contractors
CertainTeed, GAF, IKO, Owens Corning and Alside logos

Get your free estimate

516-987-7478
ADVANCED ROOFING SIDING AND GUTTERS 316 Old Farmingdale Rd
West Babylon, NY 11704
BBB Accredited Business, A+ rating Advanced Roofing Siding & Gutters box truck
Step 1 of 2
Is this an insurance claim?